Acme-RFC4824 Acme::RFC4824 is a module that tries to help you with the implementation of RFC 4824 - IP over Semaphore Flag Signaling System. INSTALLATION To install this module, run the following commands: perl Makefile.PL make make test make install SIGNALING If you don't care about the module's details and just want to use it for routing IP over SFSS, you can use the scripts in the example directory (note that you need Net::Pcap for them): # ipsfss_receive.pl [filter] Receives packets from an interface and shows you what to signal. So say you want to signal all packets to 10.23.23.23 arriving on en0, just use # ipsfss_receive.pl en0 "ip and dst 10.23.23.23" # ipsfss_send.pl If you receive signals from someone, you can use ipsfss_send.pl to convert those frames into IP packets. Say you accept frames for 01:23:45:67:89:0a and your MAC is 00:11:22:33:44:55:66, you can run it as # ipsfss_send.pl en0 00:11:22:33:44:55:66 01:23:45:67:89:0a Please note that both example programs assume an interface which either is or looks like Ethernet. UPPORT AND DOCUMENTATION After installing, you can find documentation for this module with the perldoc command. perldoc Acme::RFC4824 You can also look for information at: Search CPAN http://search.cpan.org/dist/Acme-RFC4824 CPAN Request Tracker: http://rt.cpan.org/NoAuth/Bugs.html?Dist=Acme-RFC4824 AnnoCPAN, annotated CPAN documentation: http://annocpan.org/dist/Acme-RFC4824 CPAN Ratings: http://cpanratings.perl.org/d/Acme-RFC4824 COPYRIGHT AND LICENCE Copyright (C) 2007 Alexander Klink This program is free software; you can redistribute it and/or modify it under the same terms as Perl itself.